Browsing by Author "Bentz, Dale"
Now showing 1 - 2 of 2
Results Per Page
Sort Options
- ItemApplication of internal curing for mixtures containing high volumes of fly ash(ELSEVIER SCI LTD, 2012) De la Varga, Igor; Castro, Javier; Bentz, Dale; Weiss, JasonThis paper focuses on testing performed on mixtures that would be consistent with the mortar portion of a concrete bridge deck mixture for many state departments of transportation. In this work a relatively large percentage of cement (40%, 60%, or 80% by volume) is replaced with Class C fly ash. To overcome concerns associated with slow set and early-age strength development that are often expressed with the high volume fly ash mixtures (HVFA), the water-to-cementitious materials ratio (w/cm) by mass has been reduced from a conventional value of 0.42 to 0.30. To overcome potential complications that the low w/cm may cause in terms of self-desiccation, internal curing (IC) with prewetted lightweight aggregate was used to reduce shrinkage and increase hydration. By adopting this approach (lowering the w/c and using IC) IC HVFA mixtures show additional benefits that should permit their broader application. (c) 2012 Elsevier Ltd. All rights reserved.
- ItemEffect of sample conditioning on the water absorption of concrete(ELSEVIER SCI LTD, 2011) Castro, Javier; Bentz, Dale; Weiss, JasonASTM C1585 is commonly used to determine the absorption and rate of absorption of water in unsaturated hydraulic cement concretes. Unfortunately, a wide range of relative humidities can exist in the samples after this relatively short conditioning period and such variation may considerably influence the test results. Three main variables were studied in this program: the water to cement ratio, the paste volume fraction, and the effect of sample conditioning. The results confirm that water absorption testing is considerably influenced by sample preparation. Samples conditioned at 50% relative humidity can show up to six times greater total absorption than similar samples conditioned at 80% relative humidity. Samples that were conditioned in the oven at 105 degrees C do not appear to follow a similar trend when compared with specimens conditioned in chambers at lower temperatures for a longer duration. The absorption is also influenced by the volume of paste in the samples. The experiments show that a lack of control on moisture content or lack of consideration of the material composition may lead to a misunderstanding of the actual absorption behavior. (C) 2011 Elsevier Ltd. All rights reserved.